Welcome to the Gundam Forums.

Search:

Type: Posts; User: gundammonkey

Page 1 of 12 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    570
    Views
    49,751

    Three plates would make up the armor. on the...

    Three plates would make up the armor. on the outside edge i would put "C" or "L" Plata tubing and then on the top of the second and third a round solid piece of plata. Then cap off the bottom of each...
  2. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    Crap! With all of this Modding going on with this kit. Just how much of it will still be the GM/GM at the end?? the build off was GM\GM -V- GM\GM. But then again my brother did say no limit to the...
  3. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    YA, without the arms and weapons on he looks a bit bottom heavy and the legs look weird. Like you said , like the thighs need to be thickened a bit. Until I get the chest and arms to a point that I...
  4. Replies
    570
    Views
    49,751

    The waist mod is now about half finished. I still...

    The waist mod is now about half finished. I still have to cut the rear armor into two parts like the front is. Then the legs will be back to full mobility.
    But at least he is in line. The center of...
  5. Replies
    473
    Views
    42,983

    Re: RPC's WIP ~ my first MG's

    I have been loking at reviews of that "True Metal" stuff. It looks good on your kit. I might have to try it out. Did you mask off or just go free hand?
  6. Sticky: Re: The Airbrush question thread. Ask questions here and not in a new thread.

    How about a picture for reference.
    It sounds like it is the trigger tension clip thingy. Dose it look like a small letter "C" if so the open end should face the trigger. The curved part should go...
  7. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    The red part is the part I will be cutting into 2 parts. Below the line is one and above is the other. When bending over the top will go over the bottom. It comes as one piece and it goes the whole...
  8. Replies
    570
    Views
    49,751

    Well now that I have the legs and waist sorted...

    Well now that I have the legs and waist sorted out. Just finalizing the little details and a few more “fit and finish” bit and I can call the lower half done phase 1.

    Next big Mod. The chest and...
  9. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    Thanks. I went with that decision as well last night. I did a bunch of measurements and looked at what the 2 mods would do. If i moved the back in it would no longer line up with the top half of the...
  10. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    Ya that is just on with blue tack to see what it would look like with different back armor. I have tried a few different ones to see if something grabs me. That is part of the reason nothing was said...
  11. Replies
    570
    Views
    49,751

    I’m almost done with most of the Mods to the...

    I’m almost done with most of the Mods to the GM/GM. I still have a few to do and one that is up for question and debate.

    First the head. I shaved off a good bit of the back of both the head and...
  12. Re: Mobile Suit Gundam: The First Colony Discussion Thread

    works for me. Jack is just doing Sim stuff and that can get boring really quick.
  13. Replies
    53
    Views
    4,313

    Re: Painted custom MG Astray Red Frame

    That is the MSV, The astray was not in SEED or Seed Destiny. Well it was in the very last episode of destiny but not a main suit in the show. The Red Frame MSV was its own show based off of the manga...
  14. Replies
    5,627
    Views
    494,732

    Sticky: Got these in the mail today! Now I can get back...

    Got these in the mail today! Now I can get back on theYamato and with real railings this time.
    https://uploads.tapatalk-cdn.com/20180521/dc22286a3b2a9041b4ea1eb13b418a2e.jpg


    Sent from my iPhone...
  15. Replies
    570
    Views
    49,751

    I can finally get back to work on the...

    I can finally get back to work on the Spacebattleship Yamato! The railings I had were OK. But they still just needed so much work to make them fit right or look right. And the actual “railing” part...
  16. Replies
    5,627
    Views
    494,732

    Sticky: Re: Latest Kit Acquisitions!

    No No NO, he is an imposter. This is the prince of darkness. The King of hell.

    21034
  17. Replies
    60
    Views
    1,943

    Re: Vile's Project Room

    I would go with the 7th it is already built up and just a bit of body filler in two spots is easier than a full on scratch built shoulder.
  18. Replies
    53
    Views
    4,313

    Re: Painted custom MG Astray Red Frame

    If my memory serves me right the Astray Tactical arms was not in the Seed anime, but it was in the Manga. That is where they get all the add ons from. The astray is not in "Seed" or "Seed destiny"...
  19. Re: My Perfect Grade Wing Zero Custom 1/60

    Damn you have 4 buster rifles for him! Sweet.
  20. Replies
    570
    Views
    49,751

    Here is how I made the waist work. At first I had...

    Here is how I made the waist work. At first I had a few “miss haps” but I got it to work out.

    https://uploads.tapatalk-cdn.com/20180518/7cde567d3bbf9921414d4122c4a44d63.jpg
    First I cut the pegs...
  21. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    Not a bad idea. Hummmmmm ligaments and tendons......I have very small springs and fine wire line. Let me look into that. But really that would be a B***H to do on 1/144th scale, but not a bad idea. ...
  22. Replies
    570
    Views
    49,751

    Yes the nubs. Like I said this is the first...

    Yes the nubs. Like I said this is the first “snap” build part. Still not really sure if these are the bottoms of the legs I will be using. I will get all the nuns taken care of when I get to the...
  23. Replies
    570
    Views
    49,751

    Well here is the Mod I wanted to show you all. ...

    Well here is the Mod I wanted to show you all.

    I wanted better articulation so I had to rebuild the joints. I had an idea and went with it. It is working out really well so far. I have a bunch of...
  24. Replies
    570
    Views
    49,751

    Re: Monkeys Garage

    The base kit is actually really good. Well for a Feddy that is. :) But it is a blank canvas to build on.
  25. Replies
    570
    Views
    49,751

    My brother (okier29) are having a build off. We...

    My brother (okier29) are having a build off. We are both building a GM/GM from build fights. Mods are a must and the end date is his birthday ish. (I got the kit late in the mail so the end date was...
Results 1 to 25 of 300
Page 1 of 12 1 2 3 4