PDA

View Full Version : update on hydralic peice (prototype)



thermoshok
July 16, 2014, 8:38 PM
before 7981 after 7980

finally figured something out different still in working stage i cut off the plastic instead of sanding didnt work so well and got my scrap metal peices and replaced inner plastic with a 1/32 peice of copper pipe still got to tweak it a little took about 20 minutes to get it right. any comments are welcome is it good to use or not etc.. I will paint it red most likely so it doesnt turn green its not glued yet, these are two different hydralic peices but same function just different ones on leg

Squee
July 16, 2014, 8:54 PM
What is this for?

thermoshok
July 16, 2014, 8:58 PM
on the inner frame of shin musha i wanted to paint the hydralic piece of the endoskelton so i improvised it. if it looks stupid let me know please

Squee
July 16, 2014, 9:09 PM
Ah, thats pretty sweet! Replacing plastic with metal is almost always an improvement.

thermoshok
July 16, 2014, 9:15 PM
thanks man. i tried heating it but didnt work so well so i used the pin vise and drilled just deep enough to insert it but gonna supper glue it and paint the hydralic red i want the whole inner frame painted